Create a Sketchable Face

I'm sure that I am missing something obvious here, but I cannot figure out how to create a face planar face that SolidWorks recognizes as "sketchable". I am using SW2017 SP3 and PowerSurfacing 4.1 (demo). Here is my workflow:

  1. Create a box with the default dimensions (10,10,10 in).
  2. Select one face of the Sub-D and click Hard Edge. I get the following:
  3. Click OK to return to SW.  I get the following:
  4. Right click on what should be a planar face and look for the sketch on face command. (It's not there)


So my question is what am I missing here? 


Photos (4)
Original Post

Add Reply

Likes (0)
This is an IntegrityWare Product